Well it figures...... found 3 out of 4 rubber
grommets for my rear bumper rods. I guess that's
not too bad after 4 years of building. Need a
source for these grommets. Need 3/ ...
I am building a 408 stroker with EFI that I am
going to put into the cobra. Current Motor has
2500 miles. I had this one on the chassis dyno and
ran 324hp/350tq at the wheels ...
I am setting up a group buy for Stainless Steel
Cobra Roll Bars made out of 304 Stainless Steel
2"OD x.120 wall (#4 Spun Brush Finish).
The more ordered, the better the disc ...
BDR requires a 4 1/2 backspace on the front 8 inch
wheel in 15 inch. Rear wheel requires 5 3/4 inch.
backspace with 10 inch. in 15 inch wheel.
Will consider very reasonable ...
