Thread: 90 Degree Angle Drill
View Single Post
  #5 (permalink)  
Old 01-25-2010, 12:36 AM
Zedn's Avatar
Zedn Zedn is offline
CC Member
Visit my Photo Gallery

 
Join Date: Jun 2009
Location: Sydney, NSW
Cobra Make, Engine: RCM, Jag front and rear, LS3
Posts: 1,640
Not Ranked     
Default
Most hardware stores sell flexible hose attachements also that allow you to get in tight spots.

I reckon you would go through a lot of drill bits going at the speed of a grinder, especially in thick steel.

Good idea though.

Liam
Reply With Quote