View Single Post
  #1 (permalink)  
Old 10-12-2010, 04:05 PM
Nigel Pearson Nigel Pearson is offline
CC Member
Visit my Photo Gallery

 
Join Date: May 2006
Location: Cranbourne Vic, Vic
Cobra Make, Engine: Classic Revival
Posts: 57
Not Ranked     
Default Emmissions test at Vipac

Hi guys, just thought i would share my experience at Vipac Test Lab (Victoria) yesterday where my cobra went for its initial Emissions test (IM240), cheaper alternative to full ADR testing. The test was a pass on two runs on the dyno. It was a Classic Revival with 6.0 litre and 6 speed manual it was fitted with custom headers directly coupled to VE SS cats with O2 sensors either side of cat, from cat to custom side pipe muffler back in under vehicle exiting to rear thru x-force resonators. The computer was set up by LSX Conversions to standard VZ 6.0 with MAF, to suit cobra requirements. Intake twin pod filters.

Cost for test $550 inclusive of GST and allow about two hours for testing although each of the actual test recordings are done over a 4 minute period.

Off to engineer next week.
Reply With Quote