Thread: Jag Diff Toe-In Measurements
View Single Post
  #8 (permalink)  
Old 02-15-2011, 06:42 AM
Rebel1 Rebel1 is offline
CC Member
Visit my Photo Gallery

 
Join Date: May 2002
Location: Brisbane Australia, QLD
Cobra Make, Engine: RMC under re-construction, GenIV with tremec 600, Jag 3.31 L/S diff
Posts: 3,318
Not Ranked     
Default
Jamie, My wishbones were supplied by RMC and I also assumed they would be square. They were only out a few thou but when you hang a 15" wheel fitted with a 26.5" tyre off the end they end up all over the place and it was damn near impossible to get both rear wheels aligned correctly. Cross fingers yours are better than mine.

But it is worth the effort to get them right as they are a proper bugger to do anything with once the car is built.
__________________
It's impossible to soar like an eagle when you're surrounded by turkeys.
Reply With Quote