Thread: Drive shaft angle for Everett Morrison
View Single Post
  #24 (permalink)  
Old 04-10-2011, 05:47 PM
Tom Cimino's Avatar
Tom Cimino Tom Cimino is offline
CC Member
Visit my Photo Gallery

 
Join Date: May 2006
Location: Concord Twp., OH
Cobra Make, Engine: Everett-Morrison 427SC 302 smallblock. 431 stroker in the works, tremec 3550
Posts: 200
Not Ranked     
Default
I can not seem to find the receipt for my wheels, so I can't accurately tell you the width and offset, but I know the rear wheels are less than 9 1/2" wide. The axle housing is 57" flange to flange. I'm running BFG. 275/60X15 tires on Image Modular wheels. I hung a plumb bob off the rear fender and measured the distance from the widest section of the flange to the fattest section of sidewall and got 1 1/4". I know this info doesn't help much without knowing the offset and width of the wheel. I'm still looking for the receipt. I'll get back to you then.
Reply With Quote