Thread: Beam and Torsion tests in Victoria
View Single Post
  #18 (permalink)  
Old 08-01-2011, 04:32 AM
Zedn's Avatar
Zedn Zedn is offline
CC Member
Visit my Photo Gallery

 
Join Date: Jun 2009
Location: Sydney, NSW
Cobra Make, Engine: RCM, Jag front and rear, LS3
Posts: 1,640
Not Ranked     
Default
Dave that was Peter Smith quote. Thats why i was asking you about the rig you used at the time. Luckily RCM have already had the test done to VSB14.

I have heard similar prices around the $1500 mark. It sounds a lot, but when you consider the time it takes for them to make up something to adapt the hubs and get it all set up, carry out the test and then write a report, all at engineer rates its about right.
Reply With Quote