Quote:
Originally Posted by FIA-ERA
At the end of the day I've always been told, take you parts to the engine builder and let him decide what to do, not you.
|
I don't think I necessarily agree with that. Just in the same way that you wouldn't just hand a home builder a pile of 2x4's and say, "Build me something...", you wouldn't hand an engine builder a bunch of parts and say the same thing.
I'm looking through my email list of some current customers right now.
I'm building a 408C for a customer right now. It will be getting its own magazine article in Modified Mustangs & Fords magazine. He and I have sent 87 emails back and forth, pertaining to his build.
A customer that's getting a 410W short block: 61.
A customer that's getting a 482FE all aluminum FE: 295...hahahah (that one's an aberration, he's in France, and he has had two engine projects going on at once)
So, with that being said, communication is key.
Dual plane intakes can be made to perform as well. My 482FE engines with Performer RPMs and ported Edelbrock heads will make 580-600hp.
With the intakes that you have, I would either do the 2x4 single plane (which would require a little more tuning attention on your part), or the 1x4 dual plane.
Tunnel Ports are like any other engine: cubic inches makes the hp/tq curves broader. You can make horsepower and you can keep a broad torque curve as well. You essentially have 3 crankshafts available to you: a 3.98", 4.125", and a 4.250". That would be around 450 cubes, 468 cubes, and 482 cubes respectively. In a heavier car, such as a vintage Mustang, I personally would go with the 4.250" stroke and let the engine make gobs and gobs of torque.