Quote:
Originally Posted by blykins
I saw a lot of Clevite bearings with a lot of taper in them at the beginning of the year. I measured a few and they had .0004-.0005" from one side to the other. I got tired of going through 2-3 boxes of bearings...and that gets pretty expensive.
I've been running a lot of ACL stuff and they seem to have a better handle on their consistency.
|
2-3 boxes.....over a tenth? can't see where it is that critical. 10 degrees in air temp would change the measurement...
well, point made, now i'll be going over bearings with a pin mic....hehehe
build was done in 2006