View Single Post
  #8 (permalink)  
Old 01-08-2015, 01:53 PM
lovehamr's Avatar
lovehamr lovehamr is offline
Stolen Avitar
Visit my Photo Gallery

 
Join Date: Oct 2004
Location: Brunswick, GA
Cobra Make, Engine: BDR 1311 428PI
Posts: 3,044
Not Ranked     
Default

My first BDR (687) did that and only had the 3/8 vent from the corner of the tank to fairly low in the fill tube. The tank had to be filled very slowly like you are descibing. My current car (1311) has that same 3/8 tube but connects in the fill tube several inches higher than my old car did. In addition I also have a smaller vent at the top of the tank off of the center plate where the internal fuel pump is mounted. With these 2 vents and the higher location in the fill tube I have no problem at all fueling. Hope that helps. Steve
Reply With Quote