Thread: Hydraulic clutch cylinder sizes?
View Single Post
  #15 (permalink)  
Old 07-31-2015, 06:04 AM
Davekmd Davekmd is offline
CC Member
Visit my Photo Gallery

 
Join Date: May 2015
Location: Sykesville, Md
Cobra Make, Engine:
Posts: 32
Not Ranked     
Default Thanks!
Folks, thanks for the many suggestions and recommendations. I hope to get at the hydraulics/mechanicals this weekend and gather some facts. The slave IS a Wilwood Pull type but the Wilwood site lists the bore as 3/4" on one page and 7/8" on another page for the same part number. I figure the only way to tell is remove the darn thing a measure. I'll do the same for the clutch cylinder. I'll check for any interference and basically lubricate any moving parts.

I hope to post better news Monday!
Thanks again, Dave K.
Reply With Quote