Roger,
You mentioned in another thread from around four years ago...
Quote:
Originally Posted by rsk289
....I think it's just the dash bottom compound curvature that is the problem area, and some on the ACOC have suggested steam whilst glueing it down. I have spare scraps so will practice a couple of techniques first....
|
Did you have any trouble with that radius on the lower edge of the dash (in the area around the dropped-centre?) as mentioned above?
Also, the radius into my glovebox opening is quite severe; any suggestions as to how to handle this area? I'm assuming that the most likely solution here is pie-cutting?
Cheers,
Glen