Quote:
Originally Posted by blykins
You don't have to wait on them, it needs to be an interference fit. Otherwise, there's no use in dialing in a bellhousing. If it's a slip fit/sloppy fit, your trans is not going to be on the centerline each and every time.
|
That's what I said to the tech over there, I also asked what the BH bore tolerance was, he claims +/- 0.015" I laughed, what's the sense of indicating the bell housing then.
Maybe I shouldn't have scraped of the powder coating on the inside of the bore off. That would have given me a closer fit.
I don't think it is good to have the mating surfaces powder coated, seems like it could cause some R/O problems if the thickness isn't exactly uniform.
I'm beginning to feel I should have spent my money on a different brand, but they were highly recommended one here.