Thread: Ford Engine Harness Install ?'s
View Single Post
  #16 (permalink)  
Old 08-22-2002, 11:28 AM
ronzara's Avatar
ronzara ronzara is offline
CC Member
Visit my Photo Gallery

 
Join Date: Sep 2001
Location: Myrtle Beach, SC, SC
Cobra Make, Engine: Everett-Morrison 351w assembly STILL in progress
Posts: 276
Send a message via AIM to ronzara Send a message via Yahoo to ronzara
Not Ranked     
Default
OK Guys,
Still NOTHING. I connected 121 and 126 from under the dash together.
I am using a lokar auto shifter and have connected the trans harness wires to each of the 2 poles on the neutral safty switch. I have don't done anything with the back up light wires (nothing to attach them to and also will not be using them. Do they need to be connected to anything?

I checked power with my meter at the ignition switch, seems to be sending current through when I hit the key, I checked the solenoid ..... nothing.

The red wire on the ignition switch seems to be getting pretty hot.. is this normal?

I have the BATTERY and ACC wires attached to the left side of the solenoid (Silver Lug) and the starter out attached to the right side (Copper Lug). Thought maybe these are backwards ????
I am stumped....
RZ
__________________
Ron Zara
ronzara@hotmail.com
1. "Putting a Chevy Motor in a Shelby Cobra is like CUSSING IN CHURCH!"...... ME
2. "Friends Don't Let Friends Drive Junk"....
Last edited by ronzara; 08-22-2002 at 11:32 AM..
Reply With Quote