[LateApex]

Don't spend much time on this, I just figure someone may know off the top of their head. I am building a 392 Hemi motor for a streetrod project. I can get tranny adaptors for either Chrysler or Chevy/GM style manual trannies from one particular source.

I want to run a 6 speed if I can. Ideally a Richmond 6 speed (new improved version of the Doug Nash 5 speed--they bought the tooling), also a T56, or ZF ( from the pre-94 Vettes, a little too bulky though) may work.

Does anyone know if the Richmond would support the bolt patterns on a bellhousing adaptor made for a GM or Chrysler manual tranny? Are there any sites that one can reference for tranny interchangeability etc? I obviously realize the drive shaft will be custom for this app, and the clutch set up may or may not be a one-off.