Now that's what I'm talkin' about!! I don't think that set up will fit under the hood though.
I figure a single blower, the big brother to those Eaton blowers and a Air-Water intercooler in the plenium directly under the blower. I'd make most of the manifold out of folded sheet and machine the mating surfaces from 12mm plate. I figure adding a chiller tank in the water circuit might be the go. That way I can keep my
VB stubbies cold at the drags.
Not looking for 800HP (planning to use stock LS1 bottom end) but I figure 550-600HP shouldn't be too hard to make.
Cheers