[427Aggie]

Goods and bads...the carbs will cost $600/ carb to start so you are at $2400 without linkage and manifold...$600 for manifold and a couple hundred for linkage...so $3500 or so.

Now the fun part...you can probably get close on a jetted by the builder setup from pierce but I have over a grand in jets and stuff alone.

Remember webers don't like lots of cam you have to stay under 600 on I think its lift right? can't remember what each number is...they have no runner so you get backfire out the top if you have too much overlap...they remove alot of the lopdy lopdy dope out of a motor.

Once you get them set they are easy but it took me about a year to learn what I needed to do it right...and I can still tweak them a little bit.

Matt