Thread: jaguar front suspension for cobra kit
View Single Post
  #1 (permalink)  
Old 09-30-2003, 09:05 PM
stevehaygood's Avatar
stevehaygood stevehaygood is offline
CC Member
Visit my Photo Gallery

 
Join Date: Aug 2003
Location: Hockley, Tx./Northwest Houston, TX
Cobra Make, Engine: B&B 427 body and building my own chassis. Modifying a Jaguar front irs and a Dana 44 in a 4 bar set up in the rear. 351W/408 Stroker I am building myself, top loader 4 speed..Dana 44 rear w/ 4 link
Posts: 85
Send a message via Yahoo to stevehaygood
Not Ranked     
Unhappy jaguar front suspension for cobra kit
Does anybody in the usa or uk (I used to live in the UK for 6 yrs and have been to virtually every cobra kit co. there) have any plans, dimensions, drawings or photos for the geometry for an independent suspension set up in the front using Jag wishbones? I have a B&B body but have built my own chassis I am ready to fabricate the frontend clip now. I also have a Heidt's "generic" crossmember to use with the original Mustang II front end.
So my plans are to install a dana44 rear end to get it on the road then re-furbish and install the jag rear at a later date. Anyone?? anything would help! Thanks very much.
Last edited by stevehaygood; 10-01-2003 at 04:11 PM..
Reply With Quote