Thread: Hydraulic Roller Camshafts
View Single Post
  #20 (permalink)  
Old 10-28-2003, 02:31 PM
Hotfingrs's Avatar
Hotfingrs Hotfingrs is offline
CC Member
Visit my Photo Gallery

 
Join Date: Dec 2001
Location: Castalia, Oh
Cobra Make, Engine: EM cobra, 450 inch sbc running a best ET of 9.14..so far..ALL MOTOR...approx 800 horse.............ERA with 482 FE..All Aluminum Engine
Posts: 1,395
Send a message via Yahoo to Hotfingrs
Not Ranked     
Default
Jamooooooooooooo, The cam I was running had .667 lift, but I think the main reason for the failure was the spring pressures..205 closed and 640 open....everything I've been researching points to about 350 open....sure hope I get this sorted out by spring.

BTW do you need to borrow some chips to get your rpm up...LOL...I had been shifting at 7400, but the cam I'm looking at now puts peak power at 6500, but a nice wide torque band with just a little over 500lbs at 2000 and a little over 600 from 4500-5500 peak horse at 6500
__________________
Jack
XSSIVE .....
Reply With Quote