03-29-2004, 07:49 AM
|
|
CC Member
|
|
|
Join Date: Feb 2003
Location: Kennett Square,
PA
Cobra Make, Engine: SPF / 514 Stroker
Posts: 45
|
|
Not Ranked
Oil Cooler
The oil pump that circulates the oil from the block to the Rad and back to the block has loosened up twice in the last 2months and sprayed oil all over the place. I'm lucky I saw it both times or it could have been a disaster. (if I wasn't paying attention to my press guage)
When tightening it should I be careful not to crack the housing...how much torque can I put on that bolt and not break something?
Any suggestions on how to make sure this doesn't happen again?
Thanks |
Linear Mode
