[OhBuoy]

Carlo has a B&B. There is a reference to his build site on the B&B Manufacturers forum on this board. The old B&B floors used 1/4" x 2" "legs" that the seats would sit on inside of the floor pan. The lap belts would bolt to these legs where they made an upturn at the rear cowl. The new design has a solid raised floor pan that replaces the legs. Also, there are ears welded to the outboard frame rail, and an excentsion to the inboard frame rail (tranny tunnel) where the lap harnesses can bolt to. This puts the lap belts into the alignment and positioning recommended by Simpson Racing Products.