We are building a 70 Shelby GT500 Convert. Clone (Super-
Street). We nascar tubbed the front end a installed a Mustang 2
R&Psteering setup. The shelby front end was made into a 1 piece
Filp-top front end like a Daytona. The rear was tubed as much as we could and with Myier fender flares, we were able to run 15.5"
x 15 Hoosier prostreets on the back with 5" prostreets on the front . Car has a full 2x4" frame with lower cross-over tubing almost like the Eleanor cars have.Full coil-over ,9" Currie rear end
narrowed 4" with a 40 Spline,Detroit locker runing 3.25 R&P.we
are using a Richmond 6 speed ,lakewood setup for tranny.Car has a 34Gal. Fuel cell in trunk with a flip-top Gas cap located on the top rear pass. fender. Batteries in trunk.
Motor is Shelby's 427 Alum. Stroker motor (454) with a MSD Crank
trigger supercharger box for spark. The 2x4 intake is using a custom built blower hat made out of a Cobra oval air cleaner wrapped in Phonilic with to 660's inside.
What we need is a Pulley setup for this motor. We would prefer
a Billet setup including AIR Conditioning. If any one knows where we can get a pully system in a setup like this, we thank you in advance! Email us here or at
bjmustangs@azalea.net
Thanks,
John & Becky Davis (MUSTANGWIZARD)
