[Dominik]

Tom, the pic is good, I check later today.
I need confirmation, so we open the shop on this sunday to have a look - maybe have a beer or two...

I marked the position for a potential hole in the chromed pan already.
Not sure where it should be, probably where a main cap is, that a swinging rod does not catch it...

I keep an eye on Canton, as well as windage trays, but as you realised: parts are not just around the corner here!
I wonder if there is a dip stick with weld-to pan fitting, or I "pry" one off from a Chevy...

Thanks for all the advise,

Dominik