Thread: Are No Name TO bearing any good?
View Single Post
  #1 (permalink)  
Old 03-06-2005, 02:43 PM
The Dreamer The Dreamer is offline
CC Member
Visit my Photo Gallery

 
Join Date: Jul 2002
Cobra Make, Engine: KMP329 w/KC489 Shelby
Posts: 392
Not Ranked     
Default Are No Name TO bearing any good?
My transmission source forgot to send my TO bearing even after reminding him several times. Anyway, I need to source one locally. What I have found is there are numerous ones available at much cheaper prices than the McCleod one I was going to buy. Are these no name TO bearings just as good or am I going to have to pull the tranny to replace it because it will not hold up? It is going with a 12in McCleod pressure plate and disk behind a Shelby block putting out well over 600 FWHP.
Reply With Quote