Mando
Sounds like you are well on the way.
The roller tool is at McDonald's Racing in Melbourne. They can be contacted on 03 9 465 0000. Russell is the best person to speak to there.
He will roll them for you and send the panels back. Should not cost much as they are all flat panels? I just marked the location of the lines in marker and he rolled them accordingly.
Your local sheet metal person may also have a similiar tool.
I will try and get over to Adelaide once I get the Cobra back from Aussie Mike. We are re doing the exhaust - completly. Longer muffler sections and better baffles.
A few modifications have been made to the motor, I know I have pulled horsepower out of it drastically, but it should be more streetable - and legal..
A few smaller parts are being replaced, new alternator bracket, accelerator cable brackets etc.