Thread: Cobra.au Side Pipe Build
View Single Post
  #6 (permalink)  
Old 09-13-2006, 02:23 AM
Cobra.au's Avatar
Cobra.au Cobra.au is offline
CC Member
Visit my Photo Gallery

 
Join Date: Mar 2001
Location: Central Coast Sydney, Australia, NS
Cobra Make, Engine: Classic Revival, Gen3 ls1, Vortech T-Trim, Motec, tremec M12, wilwood brakes.
Posts: 319
Not Ranked     
Default
Spookypt
I am currently running side pipes that are 2.5" perf tube with no packing, the cat converters left the building along time ago and the slip fit joints suck in so much air that when you back of from high rev's and the extra fuel from being on boost it back fires shoots a big ass flame out the exhausts everyone with in a 100m radius hits the deck thinking that the terrorists have finally struck and if your lucky a nearby car alarm will go off and then I try to idle away pretending it wasn't me.

So I think no matter how I build my new pipes they will be quieter.

PS. The last time i was pulled over by the police (followed me for about 5K taking it easy) they didn't stop me for the noise they stopped me because they thought my front number plate was on to much of an angle.
Go figure?
__________________
Craig W
Central Coast NSW
Last edited by Cobra.au; 09-14-2006 at 03:23 AM..
Reply With Quote