Thread: Distributer gear pin sheared off
View Single Post
  #12 (permalink)  
Old 09-30-2006, 08:11 PM
chas427fe chas427fe is offline
Senior Club Cobra Member
Visit my Photo Gallery

 
Join Date: Feb 2006
Location: Ft. Mitchell, KY
Cobra Make, Engine: B&B, 428 FE, toploader
Posts: 151
Not Ranked     
Default
Thanks for all the other post. Before I read all the other post I had already drill it out and put the 3/16 pin in. Yeehaa. I am up and running again til the next hurdle. Some other points made were the the steel gear which was installed by Keith Craft based on the cam he installed. The oikl pressure is back to 60 PSI at start up. I will take it out tomorrow for a test ride. Chas
Last edited by chas427fe; 09-30-2006 at 08:16 PM..
Reply With Quote