[shelby racer]

Originally Posted by kris-kincaid

I have had to cut apart that tube and reweld it, but lately the headers I have been getting have fit nicely. Do you have the engine installed in the chassis level? Have you cut the tacks on the tube and tried to move it around on the flange?

Shelby does have a set of headers for an aluminum car that route that tube under the steering shaft. Maybe you can replace that one tube?

Shelby headers can be a nightmare.

I was hoping they would just send me a new tube - not so much...
Shelby installed the motor for me so I am hoping it is done right. I have tried to manipulate the tube with out cutting it without any success. I am probably going to have to cut and reweld it...