[Kramer]

Rick...thanks for the reply, however there is no way that airbox on the TWM website is going to fit under the hood...I was really hoping there was some individual units I could stick on each stack.

Xracerbob...thanks for the feedback on the motor..since you seem to know about these setups a bit, do you think it is possible for me to fab individual units out of foam? I was thinking of making individual units with some screening on top(to hold them in place) and bottom (to prevent them getting sucked in), however I don't know what material to use? I agree that I could probably live without, but this engine is an unmolested standard bore 427 and I would rather protect if if there is a way to to that without too much effort.