Quote:
|
Originally Posted by Tallguy
I do have one last question... What I can not find are the dimensions for the clutch fork. I plan to run a 438 FE and a TKO 600 with a blow proof bell... I am trying to figure out what clutch fork would be used....
|
Quote:
|
Originally Posted by patrickt
I believe the TKO600 uses a standard Ford small spline fork, D0TZ-7515A.
|
Hey Mark,
I measured an extra fork I have, p/n DOTZ-7515B, which is what I used on my FE/Lakewood/TKO600. I don't know what is different from the D0TZ-7515A.
Pivot to throwout bearing centerline= 3-7/8"
Pivot to slave rod push point= 6-5/8"
Hope this helps!
Rodger (also an engineer - but retired as of yesterday!
)