Thread: wheel bearing dust cover
View Single Post
  #4 (permalink)  
Old 03-02-2008, 08:02 AM
Rick Parker's Avatar
Rick Parker Rick Parker is offline
CC Member
Visit my Photo Gallery

 
Join Date: May 2001
Location: California, Ca
Cobra Make, Engine: NAF 289 Slabside Early Comp Car with 289 Webers and all the goodies. Cancelling the efforts of several Priuses
Posts: 6,592
Not Ranked     
Default
The outer end of the adapters have about 1/8-3/16ths of an inch without threads. One or more small set screws could be installed around the perimeter. Just be sure they are below the surface of the threads so the knockoff could be removed without the removal of the end cap if needed.
__________________
Rick

As you slide down the Banister of Life, may the splinters never be pointing the wrong way
Last edited by Rick Parker; 03-02-2008 at 08:06 AM..
Reply With Quote