Thread: bumper supports
View Single Post
  #2 (permalink)  
Old 05-13-2008, 10:00 AM
tcrist tcrist is offline
Senior Club Cobra Member
Visit my Photo Gallery

 
Join Date: May 2006
Location: Manteca, Ca.
Cobra Make, Engine: None, sold it
Posts: 2,439
Not Ranked     
Default

I am not sure about the grommets but you can just use threaded rods for the bumperettes with thick wall alum tubing for spacers. If you are looking for QuickJacks I made a few sets. I have 1 set of Stainless steel (un polished) and I think 4 sets of Steel ones. These are for the CR. Look in my gallery and you can see a rough print that I made up for them. I don't plan on making any more so if anyone is interested. They are made from 1/4" thick material and formed, not welded.

Terry

Last edited by tcrist; 05-13-2008 at 06:08 PM.. Reason: spelling:)
Reply With Quote