Thread: Walking grinder stand
View Single Post
  #1 (permalink)  
Old 09-30-2001, 08:35 PM
lbperry lbperry is offline
CC Member
Visit my Photo Gallery

 
Join Date: Dec 2000
Location: Florence, AL
Cobra Make, Engine: FFR #4227, 302; About to take delivery on B&B Street Coupe (Daytona)
Posts: 107
Not Ranked     
Default Walking grinder stand
A little off of the subject but figured you guys would have some good ideas.
I've got a standard 8" 2-wheel grinder on a post type stand with a three legged base. Legs are 120 degrees apart with about a 3" circular foot at the end of each leg. I'm sure you've all probably seen them.
Problem: The grinder walks all over the floor when in use. Not a lot of vibration, but enough to let it walk, particularly when putting some pressure against the wheels.
I tried putting some vinyl pads under the feet but that didn't realy help much.
Any of you guys got any good solutions?
__________________
Lawrence Perry
Reply With Quote