Thread: Near Disaster
View Single Post
  #65 (permalink)  
Old 07-31-2008, 09:25 AM
cdnus cdnus is offline
CC Member
Visit my Photo Gallery

 
Join Date: Dec 2004
Location: toronto, ont
Cobra Make, Engine: 408w 500 h.p. 550 ft.lbs
Posts: 562
Not Ranked     
Default
Looking at your photos one can see clearly there is at least a portion of unthreaded area of the hub inside the spinner. On mine that is quite wide ( I will have to go out to the shop & measure to be exact ) if yours is the same you do not have enough thread holding the spinner on.
Craig

Went out & measured---3/4" protruding out of spinner.
1/2" unthreaded starter nipple--approx 2 threds=1/4" Total--3/4"

So if yours are manufactured the same, you do not have proper thread engagememt

Craig
Last edited by cdnus; 07-31-2008 at 09:47 AM.. Reason: verifying fittment of spinners.
Reply With Quote