Thread: small block HELP...keep spinning the same bearing
View Single Post
  #44 (permalink)  
Old 11-07-2008, 01:16 AM
Jac Mac's Avatar
Jac Mac Jac Mac is offline
CC Member
Visit my Photo Gallery

 
Join Date: Feb 2006
Location: Gore. New Zealand., SI
Cobra Make, Engine: DIY Coupe, F/T ,MkIV.
Posts: 808
Not Ranked     
Default
#1 Rod only feeds from #1Main, #2&5 Rods feed from #2Main @ 90°/270° , #3&6 Rods feed from #3Main @ 180° , #4&7 Rods Feed from #4Main @ 90°/270° , #8 Rod only feeds from #5Main.
Amount & duration of feed changes with options of: top main inserts only with groove, full grooved mains , cross drilling etc.

So assuming our man has cyl # correct his problem bearing is being fed from center main.
__________________
Jac Mac
Reply With Quote