Not Ranked
Doug,
I found this FAQ on the McLeod site. It sounds like you cycle back and forth between the master cylinder and the bearing.
"Bleeding should be done first at the master cylinder and then the bearing, then the master and then the bearing again."
http://www.mcleodind.com/faq.html
The pressure bleeder is probably the best be to drive all of the air out of the system.
__________________
Doug
No stop signs, speed limit - Nobody's gonna slow me down - Like a wheel, gonna spin it
Last edited by Got the Bug; 11-09-2008 at 09:17 AM..
|