View Single Post
  #7 (permalink)  
Old 12-12-2008, 03:38 PM
Shell Valley Shell Valley is offline
CC Member
Visit my Photo Gallery

 
Join Date: Dec 2000
Location: Platte Center, Ne. USA, NE
Cobra Make, Engine: Shell Valley, 514 SVO ... now a 4.6L with an AOD!
Posts: 101
Not Ranked     
Default

Dwight,
I don’t know you, and to my knowledge we’ve never even talked to each other. It baffles me as to why you feel the need to badmouth me and my company on this forum.

I refuse to get into a pissing match on here, but I’ve read too much here to just sit back and take it.

I am well aware of the problems Mike has had with his coupe. There were a couple of communication problems, a couple of application problems and a couple of things that we just screwed up. It’s a custom built car - it happens. I also know that whenever Mike has approached me with a problem, I’ve bent over backwards to make it right – whether it was our fault or not!

As for the rear end problem, we now know that we had some bad end flanges and a few rear ends left here out of tolerance. I’ve personally fixed a couple by spending a few minutes with a barrel sander to bring the race into tolerance. We have since eliminated the problem by switching to Moser flanges. I offered a solution to Mike and also to Jeff. Mike took me up on one of my possible solutions and I’m still waiting to hear back from Jeff.

BOTTOM LINE – If you have a Shell Valley and have questions – call or e-mail me!

svdana@megavision.com 1-888-246-0900

Dana
Reply With Quote