[DocDirk]

Thanks for the replies! Mickmate, the suspension is viewed with the car on three wheels, the left side frame on a jack and the left rear wheel removed. There's no added stress on the suspension at this time at all.... meaning that the square tube has no place to go when the car gets loaded or and/or hits a bump. I'm so tempted to cut out the top side of the attachment at the frame to give it up and down travel, but hesitate because I'm not a professional builder and these guys ought to know what they're building... I'm a bit hesitant to drive this thing over anything but a perfect surface, concerned that the arm/attachment point might even do some damage if it has nowhere to go... Anyone know of a good chassis / build shop in N. Calif.?

Thanks again!

Dirk