Thread: March pulley set issue
View Single Post
  #1 (permalink)  
Old 02-26-2009, 01:20 PM
cal.cheesehead cal.cheesehead is offline
CC Member
Visit my Photo Gallery

 
Join Date: May 2007
Cobra Make, Engine:
Posts: 88
Not Ranked     
Default March pulley set issue
I have a 351w that I just installed in my New Unique chassis. When I built the engine I installed a very nice Mach pulley set. Standard rotation water pump. My problem is the frame narrows at the point where the alt is located. I have no room to tension my belt. I cannot go with a shorter belt. the alt. fan interfeers with the suppor breacket. Any suggestions? Thanks
Reply With Quote