Not Ranked
You should only have about 2 or 3 adjuster threads showing below the rocker. And enough clearance so that the pushrod cup does not touch the rocker body at any point in its travel. Normally we see pushrod lengths on roller stuff come in somewhere between 8.950 and 9.050 - you're numbers do seem on the short side.
__________________
Survival Motorsports
"I can do that....."
Engine Masters Challenge Entries
91 octane - single 4bbl - mufflers
2008 - 429 cid FE HR - 675HP
2007 - 429 cid FE MR - 659HP
2006 - 434 cid FE MR - 678HP
2005 - 505 cid FE MR - 752HP
|