Thread: intake manifold ports are smaller than what's on the heads
View Single Post
  #1 (permalink)  
Old 04-08-2009, 04:58 PM
edmonds007 edmonds007 is offline
CC Member
Visit my Photo Gallery

 
Join Date: Jun 2006
Location: Williamsburg, va
Cobra Make, Engine: Superformance #1683, Roush 392
Posts: 45
Not Ranked     
Default intake manifold ports are smaller than what's on the heads
Hi, I'm changing my intake from a Performer RPM to another one with Weber 48IDA's and when I removed the Performer manifold and looked at the one with the Webers on it I noticed that the ports on the new manifold are smaller than the ports on my heads. I would like to add that the manifold that I'm putting on the car was previously installed without any serious problems. I would like to know if anyone has any recommendations or suggestions for how I should proceed? As this is my first time really doing anything to the car myself I would welcome any advice about obtaining the best intake manifold gasket. The engine is a Roush stroker 392.

Thanks,
Bryan
Reply With Quote