John,
What are you using now?
SD...,
You're jerking my rusty chain right? Oh well, I had just come back to CR'S/Club Cobra after taking a few years sabbatical and if I remember right the guys were talking about what they thought was the best way to run the harness, brake lines, etc. Well it seems a lot of the guys, because of a straighter route and actually easier, were running components down the inner frame rails, next to the tranny/flywheel, driveshaft, U-joints etc. I was going just over the edge....I have this thing about "safety" above all, so low and behold having that sermon burned into my brain cell, I turned right around and did the same thing as I was preaching against!
Actually, I just wanted to see who was paying attention!
If I remember right and not sure if I do, I think it was Masnaka who called me on it.
Rusty Bob (I like that name!)
Two more CR's. If you ever talk Dave Smith into turning loose those Mid Sate Cobras I think it would do us all good!
Wouldn't hurt him either.....hmm, then again maybe it would???
DV