[Hray]

Bob: I need four of these hinges, so to me that is enough demand to make a jig.

DV: I for sure will review your postings of door and body mounting prior to actually doing it. I am hoping your instructions will be adequate whether or not I am using hinges that open to the outside of the car, or to the inside of the car. The system and approach should be fairly close to the same.

Then again my new mouse trap may teach me another new dance lesson. I figure it to only cost me a days worth of work to attempt it. I already have the materials laying around in my metal scrap buckets.
I did successfully re-engineer the door hinges on my four door model A to make the doors adjustable rather than adjusting the body.

I am planning on making all 6 points of alignment at the cowl. If successful I will share with all. Ray