9" Air Filter Drop Base - How Much Interest?

[lippy]

I'm using a flat 9" base with a 9" K&N XStresm top. Not a dropped base. The OD of the filter needs to be 9", and the ID needs to be 7" or less, with a height of 2" or 2.25".

The problem is that the 1050, 2630, 2640, and 2710 don't state the ID, so I don't know which will work with the Xstream top. Has anyone used any of those filters with that top?

[gsharapa]

Lippy,

If you use Jegs Auto Parts and enter the part numbers you stated you can go to more information and click on specs and it will give you the sizes. The one closest to what you are looking for is the #E-1050;

#E-1050 is 9 inches OD by 7 inches ID and 2 inches high.

#E-2630 is 9 inches OD by 7.125 ID and 2 inches high

#E-2640 is 9 inches OD by 7.12 ID and 2.25 inches high

I'm using a E-2720 which is 9 inches OD by 7.5 ID and 2.5 inches high with the 9 inch E-Stream top and Bernica's flat base. It's sitting on a Quickfuel Drag 850 Double Pumper Carb.

[lippy]

Thanks Gary. Really appreciate it. I did go to the Summit site to try that, but they didn't give ID dimensions for those specific filters. For some reason I guess Jegs does.

I thought I needed 7" ID or less to work with that filter top, but it looks like you used a filter with a smaller ID. Did you need to trim it?

[gsharapa]

7.5 ID works perfectly with no trimming. The real issue is the height as I originally had a 2.75 and it was too close to the edge of the scoop with the engine offset to the passenger side a bit so I had to drop to the 2.5. The whole setup works extremely well.