Foot Box Air Vent installed

[mkassab]

A while back, I bought a foot box air vent kit from www.cobraearl.com/products/ and as one of my winter project, decided to get it installed. I didn't use all the parts, but the kit had everything I needed. You probably could save some $$s and source the parts yourself, but I went the easy way. The 12v air blowers are boat engine compartment types. I used 3M panel bonding epoxy to attached the front ducts to fiberglass. To hold the ducts in place, I first took some safety wire and glued to the fiberglass using Weld epoxy. This allowed me to "safety wire" the ducts in place then apply the 3M epoxy using a wide wood popcycle stick. It all came out pretty good. Since my ducts had two attachment ports, I used the extra flex hose to direct the air to the disc brake rotors.

Mark

[mkassab]

more pictures....

[ROBERT GWALTNEY]

Nice Job, where in the system did you put the fan

[mkassab]

Picture above don't show it well, but just aft of the horn.... look close. It was white (as in one picture) but painted it flat black as in the other picture. I attached another below.
Mark