What could I expect to make? HP?

[Clutt gt]

351w Stroked to 392
flat top piston not sure exact cr
Edelbrock RPM heads with 2.02 intake
Edelbrock RPM air gap intake
Deamon 650 carb
mild cam not sure on the specs. Has a good lump to it nothing radical.

Do you think it will be in the 400 range?

[Three Peaks]

With the 392 stroker kit, you should be running a dished piston or your CR may be too high to run reliably on pump gas. Somewhere in the 16-22CC dish would be appropriate.

Without the specs on the cam it would be hard to tell what to expect on the HP ratings. THe RPM heads aren't the best for breathing, but with a pretty middle of the road cam like a Comp cams 274 or 282 or a TW Stage 2 cam you should be able to hit 400 HP at the flywheel without too much trouble.

Bob

[blykins]

It will be in the 400's...how deep will depend on what cam you run, if the heads had been worked, etc.