Interested in adapter/spinner retainer clips??

[Bob Lacey]

We finally have our adapter/spindle spinner retainer clips .
Unlike "diaper clip" versions these will work with hub end caps in place and have a race car design.
Stainless spring steel and easy to install ,link below.

1 x set adapter/spindle safety clips : Vintage Wheels, Hot Rod and Muscle car

If above link does not work please go to:
vintagewheelsus.com select adapters etc from the menu
Bob at Vintage Wheels

[KevinW]

Looks good - presume these will work with others e.g. trigos?

how much is shipping to the uk for 1 set, and 5 sets?

pm me if easier,

thanks,kevin

[my427cobra]

Great product Bob. What is your recommendation for drilling the hole location:

Tighten the spinner and drill so the pin is snug up against the spinner?

Drill the hole one thread pitch away so you can see if the spinner has moved/loosened?

Cheers
Greg

[Bob Lacey]

Hi Greg
drill close to the spinner but leave a slight clearance to make it easier to insert the pin. These clips are fail safe rather than locking devises ,so make sure wheel is tightened with a lead hammer , mark the wheel and spinner to check for movement or safety wire.
Full instructions are included with the clips.
Bob 1619 952 4717

[Bob Lacey]

Hi Kevin
postage to UK 1 or 5 sets same cost - first class $15 or priority $25 with tracking.
Will work on Trigos and most adapters or similar thread diameter.
Cheers
Bob

[SPF1061]

Those clips look very nice. How the heck does one go about drilling the holes?

[Bob Lacey]

SPF1061
With the wheel off you should be able to drill 1/8 holes your adapter ,making sure you mark carefully and the holes are 180 degree apart.
Easiest is to remove adapter and use drill press.
Bob 619 952 4717