Club Cobra Gas - N Exhaust  

Go Back   Club Cobra > Cobra Talk Areas > ALL COBRA TALK

MMG Superformance
Nevada Classics
MMG Superformance
Main Menu
Module Jump:
Nevada Classics
Nevada Classics
MMG Superformance
MMG Superformance
Advertise at CC
Banner Ad Rates
Keith Craft Racing
MMG Superformance
November 2024
S M T W T F S
          1 2
3 4 5 6 7 8 9
10 11 12 13 14 15 16
17 18 19 20 21 22 23
24 25 26 27 28 29 30

Kirkham Motorsports

Like Tree2Likes

Reply
 
LinkBack Thread Tools Display Modes
  #21 (permalink)  
Old 02-07-2017, 10:51 AM
RodKnock's Avatar
Senior Club Cobra Member
Visit my Photo Gallery

 
Join Date: Feb 2007
Cobra Make, Engine: KMP 539, a Ton of Aluminum
Posts: 9,591
Not Ranked     
Default

Quote:
Originally Posted by patrickt View Post
Uhhhh, twenty bucks for a plastic squirt bottle? I swear you CA guys are just dripping with money.
Yes and we line up to pay $5 a cup for our Philz coffee too.
Reply With Quote
  #22 (permalink)  
Old 02-07-2017, 11:41 AM
CC Member
Visit my Photo Gallery

 
Join Date: Jun 2006
Cobra Make, Engine: Superformance, Roush 402R, Kentucky Cobra Club
Posts: 223
Not Ranked     
Default

Is the cranking required to fill bowls with a mechanical fuel pump sufficient to alleviate (even partially) an oil starved start.
Reply With Quote
  #23 (permalink)  
Old 02-07-2017, 11:55 AM
patrickt's Avatar
Half-Ass Member
Visit my Photo Gallery

 
Join Date: Jun 2005
Cobra Make, Engine: ERA #732, 428FE (447 CID), TKO600, Solid Flat Tappet Cam, Tons of Aluminum
Posts: 22,001
Not Ranked     
Default

Quote:
Originally Posted by Chilibit View Post
Is the cranking required to fill bowls with a mechanical fuel pump sufficient to alleviate (even partially) an oil starved start.
It depends on how much oil has drained down in to the pan since you last ran the car. Other factors that can affect that rate, other than time itself, would be things like the position of your oil filter and lines, and the "clinginess" of your oil. Now, FWIW, when my car has been sitting over the winter months, sometimes five or six months, for the first fire-up of the year I will disconnect the ignition (not that it would start quickly anyway because the bowls are dry) and then I crank it until I see my oil pressure gauge needle bounce up a little, then I re-enable the ignition and try and get it to start. It always takes more cranking, and pumping the pedal, to get the accelerator pump to squirt, before it fires up. In years past, when I had never bothered to keep a Battery Tender on it, there has been a time or two when I just barely got her to start before the battery gave out on the cranking. I have never bothered to squirt gas from my bottle down the primaries, nor do I even own a spray can of starter fluid. But, if I had an electric fuel pump (which I don't) I would be extra-vigilant in bringing up a little oil pressure, before enabling the ignition, if the car had been sitting for months.
Reply With Quote
  #24 (permalink)  
Old 02-07-2017, 12:06 PM
DanEC's Avatar
CC Member
Visit my Photo Gallery

 
Join Date: Apr 2009
Location: Little Rock area, AR
Cobra Make, Engine: ERA Street Roadster #782 with 459 cu in FE KC engine, toploader, 3.31
Posts: 4,519
Not Ranked     
Default

Quote:
Originally Posted by patrickt View Post
Jeez, if I had to prime it after letting it sit for just two days I would suspect a nice leak. The accelerator pump ought to get gas to it past that little orange umbrella seal if you just have a half inch, or less, in the bottom of the bowl.
Like I said - the front bowl has cross-flow ventilation with 2 vents. Dries out fast. It was restored by Holley and to the best of my knowledge is tight and leak free.
__________________
ERA 782 Running
https://www.youtube.com/watch?v=Cfge...b1-77fqwFRu7c]
Reply With Quote
  #25 (permalink)  
Old 02-07-2017, 12:08 PM
patrickt's Avatar
Half-Ass Member
Visit my Photo Gallery

 
Join Date: Jun 2005
Cobra Make, Engine: ERA #732, 428FE (447 CID), TKO600, Solid Flat Tappet Cam, Tons of Aluminum
Posts: 22,001
Not Ranked     
Default

Quote:
Originally Posted by DanEC View Post
Like I said - the front bowl has cross-flow ventilation with 2 vents. Dries out fast. It was restored by Holley and to the best of my knowledge is tight and leak free.
If you wrapped it with cling wrap from the kitchen it shouldn't evaporate much at all. Jus' sayin'....
Reply With Quote
  #26 (permalink)  
Old 02-07-2017, 02:48 PM
Dimis's Avatar
CC Member
Visit my Photo Gallery

 
Join Date: Apr 2008
Location: Melbourne, Vic
Cobra Make, Engine: Some polish thing... With some old engine
Posts: 2,286
Not Ranked     
Default Missed ya Bernica!

Quote:
Originally Posted by RodKnock View Post
Who are you and what have you done with Bernica?
Yep, the boys are back in town.
__________________
Reply With Quote
  #27 (permalink)  
Old 02-13-2017, 08:18 PM
Tim7139's Avatar
CC Member
Visit my Photo Gallery

 
Join Date: Aug 2014
Location: Syracuse, Ny
Cobra Make, Engine: Superformance #2660, FE-406
Posts: 372
Not Ranked     
Default

Do we have any reason in the world a few short cranks to fill the bowls is a bad thing?
Generally, if I go a week, usually about two 10 second cranks before I touch the pedal, then 2 full pumps and it catches. About 1/2 the time it might require another 10 second crank and 2 pump sequence to catch and allow me the feather the pedal until I get a clean, fast idle. Then it's just a few minutes until oil and water temps come off the peg and I can move off kinda slow through the neighborhood until I get heat in it.
__________________
The older I get, the faster I was.
Reply With Quote
  #28 (permalink)  
Old 02-16-2017, 06:03 AM
DanEC's Avatar
CC Member
Visit my Photo Gallery

 
Join Date: Apr 2009
Location: Little Rock area, AR
Cobra Make, Engine: ERA Street Roadster #782 with 459 cu in FE KC engine, toploader, 3.31
Posts: 4,519
Not Ranked     
Default

I think it's kind of a personal thing. I just don't like spinning a motor with minimal oil pressure at the bearings after it's been sitting awhile. And it seems like there are more start, cough, die - crank some more - moments with this approach. I just like mine to fire off on the first touch of the key and immediately build oil pressure.

But a lot of people seem OK with cranking it for awhile and with modern clinging oils it seems to do no harm that anyone can probably prove. Different strokes.
__________________
ERA 782 Running
https://www.youtube.com/watch?v=Cfge...b1-77fqwFRu7c]
Reply With Quote
  #29 (permalink)  
Old 02-16-2017, 11:07 AM
CC Member
Visit my Photo Gallery

 
Join Date: Aug 2014
Location: Mill Valley, CA
Cobra Make, Engine: ERA FIA #2064 BOSS 302 CSX2047 sold
Posts: 181
Not Ranked     
Default

I must be missing something. I have a Holley double pumper fed by a
mechanical fuel pump running at 6 pounds. Even after a month I just
jab the accelerator a few times and it starts immediately! Am I just lucky?
Reply With Quote
  #30 (permalink)  
Old 02-16-2017, 11:25 AM
DanEC's Avatar
CC Member
Visit my Photo Gallery

 
Join Date: Apr 2009
Location: Little Rock area, AR
Cobra Make, Engine: ERA Street Roadster #782 with 459 cu in FE KC engine, toploader, 3.31
Posts: 4,519
Not Ranked     
Default

Quote:
Originally Posted by Kit Coyle View Post
I must be missing something. I have a Holley double pumper fed by a
mechanical fuel pump running at 6 pounds. Even after a month I just
jab the accelerator a few times and it starts immediately! Am I just lucky?
After a month - if you just get in, pump it twice and hit the key and it immediately fires - yes, you are lucky. Need to consider buying a few lotto tickets or heading to the track.
__________________
ERA 782 Running
https://www.youtube.com/watch?v=Cfge...b1-77fqwFRu7c]
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -7. The time now is 08:08 AM.


Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: CC Policy
Links monetized by VigLink