Adapting bumper to Quick Lift

[renaissance man]

I bought these quick lifts from @Shell Valley. Upon receiving them I noticed that my tubes and screws for my bumpers are at 3 3/4 inches but the bolt holes for the quick jack are spaced only at 2 1/4 inches?

Is there a company that makes these at 3.75” spacing instead of 2.25”?

Is there some adapter plate that is made? I understand if these are the only two sizes and I don’t know who makes one for the larger 3.75”? Transition there’s no.

I would buy a hunk of steel and machine these myself, if I had the equipment, but I don’t.

[Snake2998]

I would plug the holes with shrink fit plugs and re-drill at new centers, larger washers could then be used to cover the plugs.