Auto Lift: VBM?

ohekk · #1 (**permalink**) 12-08-2003, 06:31 AM

Has anybody heard of a VBM Auto Lift?

I purchased a VBM - Model 20000 two post lift yesterday.

7000# capacity.

The price was right and was one of those impulse purchases?

VBM
1402 W Main
Louisville, KY 40203

arntztype4 · #2 (**permalink**) 12-08-2003, 03:30 PM

Hi,
Well, I never heard of that brand, but then again I've probably not heard of alot! I just installed a Bend-Pak XL9 9000# two post lift in my shop, I don't know how I ever got along without one before. I think one of the important points is: made in USA?
Good luck, I think you'll like the convenience of a lift.

ohekk · #3 (**permalink**) 12-08-2003, 06:45 PM

Arntz,

I hear you about the convenience of a lift!

I had a Globe in ground hydraulic lift in my previous shop.

Best tool I ever bought. I sold the house and the new owner is
loving it.

I had a line on a used (like new) Bend Pak and it looked like a quality lift but my ceiling is about 1" too low.

This VBM I just puchased will fit just fine. The best I can tell is it is Made in USA, is solidly built.

I've just not heard of them but then again, like you, there's a LOT of things I've not heard of.

arntztype4 · #4 (**permalink**) 12-09-2003, 02:30 PM

ohekk,

My Bend-Pak has the plate on the floor, so the only height restrictions were the heights of the two posts, which were fine.
I don't have a problem with having the plate on the floor. I suppose that if you were using a transmission jack alot, this would be a hassle! Other than that, I like having the clear area above.
I'm sure your rack will service you just fine.