02-11-2004, 08:13 PM
|
 |
CC Member
|
|
|
Join Date: May 2003
Posts: 684
|
|
Not Ranked
Quote:
Originally posted by Rick Bagley
Luke,
You don't drill holes in the valve covers to install the badges. The nicer badges are from Branda. Cut the pins off with a Dremmel Tool and cut off wheel. Use High Temp. RTV Gasket Sealant/Maker (Permatex), CLEAN both surfaces with alcohol or some other good de-greaser and stick them on. Let the RTV cure for 24 hours and they will be on forever.
|
Rick - thanks - that was exactly the advise I was looking for - funny Branda didn't suggest it. It seemed like such a shame to drill the vc's.
I think I'll put them on without badges and decide how I like the look.
__________________
Bruce
Enjoyment may be 9/10's anticipation, but that last 10% is oh so sweet....
|
Linear Mode
